Fisher & Paykel Appliance Repair & Fault Code Lookup
Find your Fisher & Paykel fault code below, diagnose the issue, and learn whether it's an easy reset or time for professional repair.
Fisher & Paykel DishDrawer™ — Fault Codes
| Code | What it means | Urgency |
|---|---|---|
| F1 / E1 |
Flood Switch Activated
Water detected in the bottom base pan. Water valve shuts off and drain pump runs continuously to prevent overflow.
|
High |
| F2 / E2 |
Motor / Rotor Fault
Wash motor rotor is stuck or failing. Often caused by broken glass or food debris trapped under the rotor.
|
Medium |
| F4 / E4 |
Heating Element Fault
Dishwasher fails to heat water to operating temperature. Check element coil resistance or controller relay.
|
Medium |
| F5 / E5 |
Lid Actuator Motor Fault
Motorized tub lid failed to seal or retract correctly before/after wash cycle.
|
High |
| A1 / A3 |
Water Fill / Drain Issue
Drawer cannot fill (A1) or drain (A3) within required time window. Inspect inlet valve or drain hose for blockages.
|
Low |
Fisher & Paykel DishDrawers use flexible ribbon cables and water lines inside the rear support arm. An F5 lid fault or communication error is frequently caused by a pinhead-sized pinch or fatigue fracture in the wiring harness inside that moving arm.
Signs your DishDrawer™ needs a professional
- Drawer continuously beeping with red indicator light flashing
- Water leaking onto kitchen floor beneath the lower or upper drawer slide
- Lid motors grinding or failing to pull down flush when cycle starts
- Dishes remaining cold and dirty at the end of full cycle
Fisher & Paykel ActiveSmart™ Refrigerator — Fault Codes
| Code | What it means | Urgency |
|---|---|---|
| F1 / E2 |
Temperature Sensor Fault
Refrigeration or freezer compartment thermistor circuit open or shorted. Cooling performance drops.
|
Medium |
| E3 |
Defrost System Failure
Defrost heater or bi-metal failed, preventing automatic defrost. Heavy frost builds on evaporator coil.
|
High |
| E5 |
Fan Motor Error
Evaporator fan obstructed or motor failed. Warm temperatures in fresh food section while freezer remains cold.
|
High |
| E8 / E6 |
Compressor / Valve Error
Inverter board fault, compressor start issue, or dual-evaporator solenoid valve failure.
|
High |
| U1 |
Ice Maker / Water Supply Fault
Water line restricted, filter clogged, or ice maker harvest sensor error.
|
Low |
ActiveSmart™ refrigerators rely on inverter compressor control. If you hear a clicking sound every few minutes and see an E6 or E8 code, the inverter board on the rear chassis is usually failing to communicate with the variable-speed motor.
Signs your Fisher & Paykel refrigerator needs a professional
- Heavy ice buildup on back wall of freezer section blocking airflow
- Constant temperature fluctuations causing food in fresh compartment to freeze or spoil
- Display panel flashing red fault light accompanied by steady alarm tone
- Water accumulating underneath vegetable crisper bins
Fisher & Paykel SmartDrive™ Washer — Fault Codes
| Code | What it means | Urgency |
|---|---|---|
| E1 / E10 |
Water Fill Fault
Washer failed to fill with water within allocated timeframe. Check inlet hose valves and mesh filter screens.
|
Low |
| E3 / E37 |
Drain Obstruction
Water failed to drain out of tub. Clogged drain pump filter, kinked outlet hose, or pump impeller jammed.
|
High |
| E7 / E700 |
Out of Balance / Direct Drive Motor
Severe load imbalance (E7) or motor phase error on direct drive system (E700).
|
Medium |
| E235 |
Lid Lock Error
Safety switch failed to engage or unlock top door latch assembly. Washer halts before spin.
|
Medium |
| E9 / E709 |
Motor Control Module Fault
Internal circuit or communication error within main motor control board (MCM).
|
High |
Fisher & Paykel SmartDrive™ top-loaders don't use belts or pulleys—they use a direct-drive stator and rotor. Numerical codes in the 30-60 range or E700 series usually point to a failed pressure transducer or a faulty Motor Control Module (MCM).
Signs your SmartDrive™ washer needs a professional
- Loud burning smell or high-pitched whine coming from tub base during drain/spin
- Washer stopping mid-cycle filled with soapy water and displaying 3-digit error code
- Lid remaining permanently locked with wet clothes stuck inside
- Tub violently banging against side walls even with small, balanced loads
Fisher & Paykel Dryer — Fault Codes
| Code | What it means | Urgency |
|---|---|---|
| Key Locks / Flashing |
Child Lock Activated
Control panel locked out. Press and hold Key Lock or Start button for 3-5 seconds to disengage.
|
Low |
| User Warning 1 |
Lint Filter / Air Flow Restricted
Airflow through condenser or vent duct is obstructed. Clean main lint screen and external vent.
|
Medium |
| Fault Code 1 / 9 |
Temperature Sensor / Thermistor Open
Exhaust thermistor damaged or reading out of safety bounds. Heating disabled.
|
High |
| Fault Code 20 / 30 |
Control Board Component Error
Internal circuit or motor driver failure on electronic controller board.
|
High |
Fisher & Paykel Heat Pump dryers have a secondary lower filter and evaporator grid. If clothes remain damp after a full cycle, cleaning this lower heat exchanger area resolves 80% of heat-related fault warnings.
Signs your Fisher & Paykel dryer needs a professional
- Dryer drum tumbling but generating no heat whatsoever
- Squeaking or thumping noise coming from rear roller bearings or drive belt pulley
- Dryer shutting off completely 2 minutes after pressing Start
- Water reservoir filling up immediately on heat pump models despite empty drain container
Fisher & Paykel Repair FAQ
How do I reset my Fisher & Paykel DishDrawer™?
Press the Power button on the front or touch panel to turn the drawer off. If the fault persists, shut off power at the main circuit breaker for 5 minutes to clear soft microprocessor errors.
Why is my DishDrawer™ continuous beeping and flashing lights?
Continuous beeping indicates a fault condition (such as an F1 flood error, door lid lockout, or drain pump blockage). Check the base for standing water or press Start 3 times to quiet the alarm.
Where can I find technician-grade repairs for Fisher & Paykel in Los Angeles?
Fisher & Paykel engineered appliances require specialized diagnostic procedures and OEM parts. Call Barry's Appliance Repair at (424) 268-9984 for expert factory-trained service.
Still seeing the error?
Our technicians specialize in Fisher & Paykel premium DishDrawers, fridges, and laundry units. Get it fixed right the first time.